You’d be hard-pressed this week to haven’t heard of Raspberry Pi computer systems with the launch of the brand new Pi5. One factor we have been happy to see, in addition to the large will increase in processing energy and different important upgrades, was that the final dimensions and footprint of the Pi5 stay largely according to the Pi4. That is nice information for Tindie makers who promote add-on equipment which brings us to this Low Profile Prototyping Board.

This practice-designed protoboard effortlessly slips into place onto the Pi’s pin headers but additionally flows round main parts just like the HDMI socket, digicam connector socket and three.5mm jack socket. Which means that it may well sit at a really low peak over the Pi board enabling your prototypes to doubtlessly slot in a typical case. The protoboard has 288 through-hole pads set out in the usual 2.54mm or 0.1″ spacing sample everyone knows and love. It’s a basic protoboard design with no connecting traces between any of the pads so that you’ll must utilise bent part leads or point-to-point wiring on your prototype.

Designed to suit all Pis from the Pi1 by means of to Pi4 we’re assured that this could additionally match the brand-new and pre-orderable Pi5. With a Pi5 and a low-profile prototyping board, we sit up for seeing what tasks individuals give you!