The brand new Raspberry Pi 5 is following the work finished on the Pico and Raspberry Pi Debug Probe in standardizing the JST-SH 3-pin connector as their UART connector of alternative. This makes it very simple to create a serial hyperlink between appropriate boards utilizing the identical 3-pin cables as are used for the SWD port on the Pico. So the following logical step was to create a Pi HAT with 6 of them!

The PicoUART6 is a 6-port UART to USB bridge that can be utilized to command and management a Pi cluster, or only a few co-located Pi 5s that you really want a straightforward serial hyperlink to. After all, you too can get a JST-SH to 0.1″ header cable so you possibly can join to simply about any TTL UART, together with all of the earlier Pi fashions in addition to… properly, nearly each microcontroller-based challenge on the market!

8086 Consultancy has a popularity for creating helpful, well-designed and sturdy devices, and that is no exception. Merely add a Pico, add the offered firmware, join some UARTs, and also you’re off to the races! It’s in a handy HAT type issue to make it simple to mount on a Pi, however it doesn’t really interface by means of the GPIO header in any respect, so it may well go above or beneath the Pi or some other HATs with ease.

Be sure that to take a look at their full retailer itemizing — there are some superior and really helpful devices there!